The gear tooth cutter frame and saw assembly are finished. The diagonal frame supports are temporary; I'm not certain where I'll be able to put them after adding the gear blank holding assembly.
Subscribe to:
Post Comments (Atom)
About Me
- Michael Ossmann
- I make hardware for hackers:
Great Scott Gadgets
Twitter: @michaelossmann
posts people seem to like
-
ShmooCon was, once again, a fantastic experience this year. One of many highlights of this year's event for me was hacking on some rad... -
Not long after I designed the 5-in-1 Network Admin's Cable several years ago, I built the first Throwing Star LAN Tap . It is a simple... -
I'd like to take a moment to properly introduce the project that is consuming most of my time this year: HackRF, a software radio periph... -
After two and a half years of programming the IM-Me by soldering wires to the test points in the battery compartment, I finally got around ... -
I recently launched Software Defined Radio with HackRF , an instructional video series that I hope will make it easier than ever for people ...
No comments:
Post a Comment